by Mitchel Dumlao May 08, 2017

3D Printing is not perfect and people have complained before how difficult it is to create a "perfect" print without imperfections.  Support Structures, striations, and rough edges have always left prints looking unfinished - not to mention post-curing for SLA parts.   Although, at the Rapid + TCT event in Pittsburgh, Formlabs introduced the Form Wash and Form Cure to tackle the issue of post-processing. Form Wash washes your 3D prints, while Form Cure is used for post-curing. 

Read The Full Article Here

Mitchel Dumlao
Mitchel Dumlao


Leave a comment